Feynlab® F50-M Super Heavy Cutting Compound

FEYNLAB® F50-M SUPER HEAVY CUTTING COMPOUND is the most advanced cutting compound for gel-coat in the marine market.

FEYNLAB® F50-M SUPER HEAVY CUTTING COMPOUND contains the most advanced ceramic aluminum-oxide abrasives. These abrasives are incredibly hard and microscopically sharp compared to the competition. This means more cutting, less diminishing of abrasives, and a reduction in product used compared to the competition.

The F50-M compound has been specifically developed to be able to compound and remove swirls and even deeper scratches from gel-coat surfaces with ease.

PRODUCT BENEFITS

• Effortless removal of even the deepest surface imperfections
• Perfect for heavily used or oxidized vessels prior to FEYNLAB® marine coating systems.
• Fast and consistent cut
• Cost saving as less product is needed when compared against the competition
• Easy to use

APPROVED SURFACES FOR APPLICATION – DO NOT apply to unapproved surfaces

Approved Surfaces:

• Gel-Coat Surfaces
• Marine Painted Surfaces 

Included 

1 kg or 5 kg of FEYNLAB® F50-M SUPER HEAVY CUTTING COMPOUND

Cautions

We encourage to always wear gloves, an approved face mask and eye protection when using any compounds or polishes.

Prepping the Surface

• Place vessel in a well lit, cool, & contamination free environment.
• Remove any excessive surface dirt and contaminants using one of FEYNLAB’s® marine washes.
• If necessary, clay the surface to remove any surface bonded contaminants.

Rotary Polisher Directions

• Shake the bottle vigorously before use.
• Prime the wool pad by placing 4 dime size dots and spread around on the area to be corrected.
• In general, begin with a 2 x 2 foot section. Decrease working area if heavier correction is necessary.
• Using a speed of no more than 1600 rpm, make 2 – 4 slow passes over the given area.
• Wipe clear with a clean microfiber towel.
• Check your results from multiple angles to ensure you have left zero residue.
• Admire your work. Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.

Dual-Action (DA) Polisher Directions

• Shake the bottle vigorously before use.
• Prime the microfiber cutting pad by placing 4 dime size dots and spread around on the area to be corrected.
• In general, begin with a 2 x 2 foot section. Decrease working area if heavier correction is necessary.
• Using a speed of 3400 – 4000 opm, make 2 – 4 slow passes over the given area.
• Wipe clear with a clean microfiber towel.
• Check your results from multiple angles to ensure you have left zero residue.
• Admire your work. Take lots of pictures. Brag about it to your friends and give the FEYNLAB® team a virtual high five.